WE HAVE STARTED TO PROTO TYPE A NEW PRODUCT USING A G.M. CENTER STEER RACK. I WILL FOLLOW UP WITH MORE DETAIL IN WEEKS TO COME.
Entries Tagged 'New Products' ↓
1960 FORD (THUNDER) RACK &PINION STEERING
February 23rd, 2009 — 60 Ford Wagon - Thunder, How-To, New Products, Uncategorized
HOW TO INSTALL JULIANO’S PRO-CLAMP
February 4th, 2009 — How-To, New Products, Uncategorized
JULIANO’S PRO-CLAMP EXPLODED VIEW.
3) PIECE CLAMP 1)MALE FLANGE 1)FEMALE FLANGE 1)ROUND NUT
BE SURE TO WELD A LITTLE AT A TIME AND ALLOW TO COOL IN BETWEEN WELDS. TAKE CARE SO YOU DON'T WARP THE SEATING SURFACE. TAKE THE SAME CARE WHEN WELDING THE MALE SIDE AND MAKE SURE YOU PUT THE NUT ON BEFORE YOU WELD
TAKE THE SAME CARE WHEN WELDING THE MALE END AND BE SURE TO PLACE THE NUT ON THE PIPE FIRST
APPLY A BEAD OF PERMATEX ULTRA COPPER HIGH TEMP SILICON TO ONE SIDE
APPLY ANTI-SEIZE TO THE THREADS BEFORE FINAL ASSEMBLY
NOW TIGHTEN THE SET SCREW IN THE FACE OF THE CLAMP.BE SURE TO LET THE SILICON DRY FOR 24 HOURS BEFORE STARTING MOTOR
SPANNER WRENCH $12.00 SOLD SEPARATELY
PERMATEX ULTRA COPPER HIGH TEMP SILICONE AVAILABLE FOR $8.00
INSTALLING 9 INCH SEAL BEAM IN 32 FORD
January 13th, 2009 — How-To, New Products
REPLACING THE HALOGEN REFLECTOR KIT SO YOU CAN SEE AT NIGHT
- REMOVE ORIGINAL LENS AND RING.
- CLIP SEAL BEAM INTO TRIM RING USING NEW WIRE CLIPS SUPPLIED WITH BULBS
- PLUG WIRES INTO EXISTING BULB SOCKET AND SNAP TRIM RING AND BULB TO BUCKET
- THE FINISHED LOOK
INSTALLING PARKING/DIRECTIONAL LIGHT 35-36 FOR HEADLIGHT
January 13th, 2009 — How-To, New Products
MARK CENTER LINE OF BUCKET
- TRACE LIGHT HOUSING HOLDING THE HOUSING 1/4 FROM FRONT OF BUCKET
- MARK SCREW HOLE 2 1/4 INCHES BACK FROM TAB
- DRILL BOTH HOLES ON MARKS
- INSTALL RUBBER GROMET IN WIRE HOLE
- INSTALL LIGHT WITH SUPPLIED SCREW
- THIS IS THE FINISHED LOOK