Classic Car Restorations & Customization

INSTALLING PARKING/DIRECTIONAL LIGHT 35-36 FOR HEADLIGHT

January 13th, 2009 — How-To, New Products

MARK CENTER LINE OF BUCKET

: TRACE LIGHT HOUSING HOLDING THE HOUSING 1/4 FROM FRONT OF BUCKET

: MARK SCREW HOLE 2 1/4 INCHES BACK FROM TAB

: DRILL BOTH HOLES ON MARKS

: INSTALL RUBBER GROMET IN WIRE HOLE

: INSTALL LIGHT WITH SUPPLIED SCREW

: THIS IS THE FINISHED LOOK

HOW TO INSTALL 35-36 FORD AEROBRITE

January 13th, 2009 — How-To

THIS IS WHAT COMES IN THE KIT. 2)HELLA BULBD, 2) ADAPTOR RINGS, 2) CUSTOM STAINLESS TRIM RINGS, 1) COMPLETE HARDWARE KIT.

THIS IS WHAT COMES IN THE KIT. 2)HELLA BULBS, 2) ADAPTOR RINGS, 2) CUSTOM STAINLESS TRIM RINGS, 1) COMPLETE HARDWARE KIT.

: PLACE TAPE ON BUCKET FOR EASE OF MARKING

: MARK HOLES MAKING SURE THE TOP OF THE ADAPTOR RING IS TOP DEAD CENTER

: CENTER PUNCH HOLES

: DRILL HOLES

: ATTACH ADAPTOR RING WITH SUPPLIED HARDWARE. (if the bulb is loose after the trim ring is installed you will have to shim the adaptor ring with shims that are in hardware kit)

: INSTALL HELLA BULB INTO ADAPTOR RING

: INSTALL TRIM RING AND CHECK TO SEE IF BULB IS TIGHT. (you may have to shim adaptor ring with supplied shims)

: THE FINISHED LOOK

3 POINT SEAT BELT INSTALL IN 1956 CHEVY PICK-UP

December 11th, 2008 — How-To

3 POINT SEAT BELTS WILL MAKE YOU TRUCK MUCH SAFFER BUT YOU HAVE TO MAKE SURE THE INSTALLATION IS DONE PROPERLY

3 POINT SEAT BELTS WILL MAKE YOU TRUCK MUCH SAFER BUT YOU HAVE TO MAKE SURE THE INSTALLATION IS DONE PROPERLY

THIS STEP BY STEP WILL APPLY TO MANY EARLY PICK-UPS. YOU CAN GET AN IDEA ON WHAT IT WILL TAKE TO MAKE YOUR TRUCK SAFER.

JULIANO 3 POINT SEAT BELT FOR BENCH SEAT INCLUEDS ALL THE HARDWARE.

START BY DRY FITTING THE BELT TO FIND A GOOD LOCATION FOR THE "B" PILLAR MOUNTING PLATE. YOU WANT TO MAKE SURE THE STRAP DOES NOT RUB ON YOUR NECK. THIS POSITION WILL BE DIFFERENT ACCORDING TO YOUR SIZE. THE "B" PILLAR MUST BE EVEN WITH OR ABOVE YOUR SHOULDER. NEVER LOWER THAN YOUR SHOULDER.

START BY DRY FITTING THE SEAT BELT TO DETERMINE A GOOD LOCATION FOR THE"B" PILLAR MOUNTING PLATE. THIS LOCATION SHOULD BE EVEN OR ABOVE YOUR SHOULDER, NEVER BELOW YOUR SHOULDER.